Tools Needed for this job.
3/8 drive ratchet
1/2 inch socket
Extend long flat head screwdriver
1/2 inch wrench
5/16 Allen or Allen Socket
Step 6 - Use a length of 1/4” inside diameter fuel line and two hose clamps to connect the fuel crossover fittings. Tighten clamps. Also tighten left tank hose clamp on the upper vent crossover line from Step 3.
Notes: Tanks are pressure tested at the factory, but it is highly recommended you or your painter pressure test it again before painting; it's cheap insurance!
For more help watch Todd walk you through this install.